Before Use:

Cleaning eyelashes

Make sure your natural lashes are clean and free of oils and makeup. Cleanse them with our makeup remover if necessary.

1. Apply the bond

Apply the bond under your natural lashes. Apply it at the roots of your lashes across the entire width to ensure all extensions have sufficient support.

2. Apply the extensions

Carefully remove an extension from the container using the tweezers. Place the extensions one by one next to each other under your natural lashes, on the bonded area. Start from the outside in. Press each extension in place with the tweezers to secure the lashes.

We recommend using 4-5 extensions per eye, depending on your eye width. Pull the extensions out horizontally for even lash length and vertically for a tapered look for a cat eye. Each row contains a different length: 8, 10, 12, and 14mm.

We recommend not getting your lashes wet for the first 12 hours to give the lashes and bond time to bond properly. This way, your lashes will be waterproof for the next 5-7 days.

3. Apply the seal

Then, if desired, you can apply sealant to extend the life of the extensions. Do this by applying sealant across the entire width of your lashes, both above and below your lashes.

After Use:

To delete

You can remove the extensions by applying our lash remover to each extension. Let it sit for 5-10 minutes. Then , gently pull the extensions off one by one with the tweezers .

You can clean your own lashes by briefly wiping them with a cotton swab or pad soaked in makeup remover. Repeat this process if necessary.

Cleaning

You can clean the extensions so you can reuse them 2-3 times. First, pour some makeup remover into a cap or bowl and submerge the extensions in it. Then wait 5-10 minutes for the makeup remover to thoroughly clean the extensions , and then remove them .

If desired, you can comb through each extension with an eyelash brush to ensure that all dirt has been removed from the extension .